CTC Store IPDSLAM-A8/A16 User Manual download pdf (Page 119)

ADSL IP DSLAM

111

5.2 ADSL IP DSLAM upgrade procedure

This section describes how to upgrade the software of your ADSL IP DSLAM.

Step 1: connect your PC with the UPLINK port of ADSL IP DSLAM by using an

Ethernet cable.

Step 2: Prepare an new ADSL IP DSLAM software (filename, IP16s_TFTP_

V243_DLINK.BIN, is taken as an example here) and the TFTP utility.

Step 3: Extract the TFTP utility, “tftp.zip”, into one directory of your PC.

Step 4: Rename the filename “IP16s_TFTP_ V243_NoBrand.BIN” as “ipam”

and put into the same directory with TFTP.

Step 5: Log in CLI by using a RS-232 cable and type the command” sysip” to

access the IP address of ADSL IP DSLAM. (This step can be skipped

if the IP address of ADSL IP DSLAM has been available).

Step 6: Activate the “MS-DOS mode” and enter the directory that you made for

TFTP utility.

Step 7: Key in the following command to upgrade your ADSL IP DSLAM:

C:\TFTP\tftputil 192.168.100.111 put adsl

C:\TFTP \tftputil 192.168.100.111 put ipam

Transfer successful: 8 bytes in 1 second, 8 byte/s

Transfer successful: 2097152 bytes in 91 seconds, 23045 byte/s

C:\TFTP\tftputil

Step 8: After entering this command, ADSL IP DSLAM will be processing

upgrade immediately. When ADSL IP DSLAM is upgrading, LED,

“MAINT” “ALARM” and “FAULT”, will be blinked. It takes 20 seconds to

complete upgrade if there is no power off during the procedure.

Step 9: Once those 3 LEDs stop blinking, the software upgrade is completed

and ADSL IP DSLAM will restart automatically.

Step 10: Enter ADSL IP DSLAM CLI again and type the command, “show

sysinfo” to verify the software version. The version shall be “2.43”

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 139 140

No comments

CTC Store IPDSLAM-A8/A16 User Manual Page 119