CTC Store IPDSLAM-A8/A16 User Manual download pdf (Page 117)

ADSL IP DSLAM

109

executing TFTP to ADSL IP DSLAM.

Example

IPDSLAM# upgrade enable

Yes or No <y/n>? y

System is in the “upgrade” mode now. You could start to upgrade the

system file.

Note: This step can be skipped, in case of without Ethernet-VLAN on each

port.

Step 3: Enter the command “ show sysip” to get the <IP address> of ADSL IP

DSLAM. If you already know the IP address, you can skip this step.

Example

IPDSLAM# show sysip

IP: 192.168.10.2

Submask: 255.255.255.0

Gateway: 192.168.10.1

Note: Make sure that the system IP and your computer is in the same subnet.

Step 4: Open another window interface, e.g., MS-DOS interface.

Step 5: Enter the command “tftputil <IP address> <get> <sf_user.cfg>” under

the directory of configuration file and control files.

Example:

c:\> tftputil 192.168.10.2 get sf_user.cfg

When uploading, three LEDs, “MAINT” “ALARM” and “FAULT”, will

blink. Unless you finish uploaded, do not shut down ADSL IP DSLAM.

Step 6: Restart the system in terminal emulation interface. The system will

restart according to your “sf_user.cfg”.

Example

IPDSLAM# restart

Yes or No <y/n>?

System is restarting now.Wait…..

5.1 Configuration Restore

Describes how to restore your configuration settings from computer to ADSL IP

DSLAM. The following procedures will help you to restore configuration:

Step 1: Open the hyber terminal interface in order to execute CLI.

Step 2: Enter the command “ show sysip” to get the <IP address> of ADSL IP

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 139 140

No comments

CTC Store IPDSLAM-A8/A16 User Manual Page 117